Design Considerations for Corrosion Protection of Transformer Bushings

1. Introduction
The long-term reliability of condenser transformer bushings is influenced not only by their electrical insulation performance but also by their ability to withstand environmental severity throughout their service life. In coastal, offshore, and industrial regions, polluted environment poses a significant challenge due to the corrosion of exposed metal components & hardware. Inadequate corrosion protection can result in premature deterioration on metal surfaces and may result into many physical and electrical defects in the bushings.
2. Corrosion Risks in Condenser Transformer Bushings
Metal components of bushings exposed to corrosion are conservator, mounting flange, HV terminal assembly components, test tap assembly components. These components of bushings when operating in coastal, offshore, or highly polluted environments will experience:
Uniform corrosion
Pitting corrosion
Crevice corrosion
Galvanic corrosion
These corrosion mechanisms can reduce mechanical strength, degrade protective coatings, impair electrical connections, and damage to sealing surface finish. Marine and offshore installations typically correspond to corrosivity categories C4, C5 & CX and require enhanced surface protection measures.
3. Material Selection and Design Considerations
Conservator and mounting flange are the major components of bushings which are either of aluminium alloy castings or of aluminium alloy fabrication. Selecting right aluminium alloy with negligible impurities including copper is crucial for long duration resistance to corrosion.
To minimize corrosion during service following constructional design aspects need to be considered in metal component designs:
Provide slope & drain paths to enable water drain & prevent water accumulation.
Minimize crevices, blind pockets, and overlapping joints where moisture may accumulate.
Consider galvanic corrosion compatibility between mating components of dissimilar metals.
Galvanic corrosion possibility can be eliminated by using non-metallic component between two dissimilar metals.
Insulating washers, sleeves, or non-conductive gaskets
Use of anti-seize compounds on threaded joints
Resin based coating metallic interfaces
4. Corrosion Protection Systems
For bushings intended for coastal, offshore, or highly polluted environments, additional surface protection is generally adopted.
Common surface protection systems adopted:
a. Anodizing: Provides a stable oxide layer with improved atmospheric and marine corrosion resistance.
b. Powder Coating: Provides a durable barrier against moisture, contaminants, and ultraviolet exposure while improving long-term weatherability.
c. Epoxy + Polyurethane Painting System: Recommended for severe outdoor service environments
5. Qualification and Verification
The effectiveness of corrosion protection measures is verified through checks during various stages of surface protection/coating and qualification testing.
Most common Verifications done:
Visual inspection for ascertaining coating integrity and coverage.
Coating adhesion testing.
Dry Film Thickness (DFT) measurement.
Environmental qualification testing such as salt spray testing
For C5 marine and offshore service environments, a total coating thickness of approximately 290-320 μm is typically specified for high-performance epoxy and polyurethane coating systems.
